Related Manuals for Mytee 2002CS
Summary of Contents for Mytee 2002CS
- Page 1 User Manual Contractor’s Special Models: 2002CS, 2005CS, 2008CS Carpet Cleaning Package REV. 4/25/23 13655 Stowe Dr. Poway, CA 92064 P: (858) 679-1191 F: (858) 726-6005 www.mytee.com...
- Page 2 Congratulations on the purchase of your new Contractor’s Special Carpet Extractor Package. As technology continues to develop you can work confidently knowing that both Mytee and its employees are equally dedicated to developing with the industry and its advances. Like any other piece of machinery or technology, the Contractor’s Special also requires proper maintenance and care to keep the product working over extended use.
-
Page 3: Table Of Contents
Table of Contents Important Safety Information At a Glance 1.1 - Technical Specifications 1.2 - Extractor Front View 1.3 - Extractor Rear View Machine Operation 2.1 - Powering the Extractor 2.2 - Filling the Solution Tank 2.3 - Connecting the Hoses 2.4 - Operating the Extractor 2.5 - Emptying the Tanks Machine Maintenance... -
Page 4: Important Safety Information
When and if calling This machine must be grounded. If it should malfunction or break Mytee for support, please have your Model and Serial Number down, grounding provides a path of least resistance for electrical available for faster assistance. - Page 5 Important Safety Information To reduce the risk of fire, electrical shock, or injury: may contain: chemicals, grease, oil, acid, alkalines, or other dangerous liquids. 1. Read all instructions before using equipment. 19. Do not leave operating unattended. 2. Use only as described in this manual. Use only manufacturer’s recommended attachments.
-
Page 6: At A Glance
1 - At a Glance 1.1 - Technical Specifications 2002CS 2005CS Solution Tank 10 gallon capacity Solution Tank 10 gallon capacity Recovery Tank Recovery Tank 9 gallon capacity 9 gallon capacity Single 3-stage low amp Dual 3-stage low amp Vacuum Motor Vacuum Motor 100 CFM, 130”... -
Page 7: Extractor Front View
1 - At a Glance 1.2 - Extractor Front View 2008CS model shown 1. Switch plate 7. Recovery tank 2. Faucet fill hose 8. Quick connect for solution hose (2005CS and 2008CS models only) 9. Prime valve 3. Lift handle (2005CS and 2008CS models only) 4. -
Page 8: Extractor Rear View
1 - At a Glance 1.3 - Extractor Rear View 2008CS model shown 1. Rear recovery tank drain valve 3. Twist-lock power cord receptacles 2. Rear body bracket screws (2005CS and 2008CS models only. 2002CS model has power cord attached.) -
Page 9: Machine Operation
1. First, prime the pump. ♦ circuits. 2002CS model: Turn pump switch on. Pull the lever on the 2.2 - Filling the Solution Tank cleaning tool to release air in the line. Hold lever until a steady flow of water comes out of the tool. -
Page 10: Emptying The Tanks
2 - Machine Operation Cleaning Procedure For best results when extracting, do one wet pass followed by two dry passes. This ensures you’re not over-soaking the material and keeps water temperature higher. The solution pump will only turn on when there is a pressure demand (e.g., while spraying with cleaning tool, or right at startup). -
Page 11: Machine Maintenance
In order to keep the extractor running smoothly and reduce the 2. Connect a cleaning tool (upholstery tool, wand, etc.) and risk of damage to the machine and subsequent downtime, Mytee remove the jet(s) in order to prevent clogging from dislodged recommends following the maintenance schedule below: mineral build-up. -
Page 12: Troubleshooting
Circuit breaker tripped in building. Reset breaker in building. turning on. Faulty switch or power cord. Contact a Mytee Service Center. Unclog the jet by removing and soaking in a vinegar Jet is clogged. and water solution. Scrub with a soft brush. Repeat if Poor solution flow. - Page 13 NOTES...
- Page 14 Mytee, LLC 13655 Stowe Dr. Poway, CA 92064 www.mytee.com © 2023 Mytee, LLC...
Need help?
Do you have a question about the 2002CS and is the answer not in the manual?
Questions and answers