Distributed Mode - JTECH TITAN User Manual

Telephone Router
3.7.1 Distributed Mode
To configure distributed mode, click Settings ‐> Distributed Mode.
1. To enable this Telephone Router unit to operate in distributed mode, select Yes.
2. In the Server field, type the IP Address of the TITAN Master Controller.
3. The Server Port field should be left at the default 80.
4. In distributed mode, the Telephone Router module queries its master during each step of a call
over the network. The Response Telephone Timeout field is the maximum wait time in seconds
that this Telephone Router unit will wait for an answer from the master unit. Default 20 seconds.
Page 20 © JTECH Communications, Inc.
User Manual