Table of Contents
Advertisement
User Manual
2
INSTALLATION
2.1
Enclosure Mounting
Before mounting the enclosure, you will need to decide where to place the unit. The
Telephone Router can be desk mounted or installed into a standard 19 inch rack frame.
Your Telephone Router package contains four adhesive rubber feet which can be placed on
the underside of the unit if you wish to desk mount it.
If the unit is to be rack mounted you will need to attach a pair of rack ears. Your Telephone
Router package contains a set of rack ears and six screws. Use a phillips screwdriver to
attach the ears to the chassis.
Use the supplied IEC mains power lead to connect 110‐240VAC 50/60 Hz supply to the
Telephone Router unit.
The phone lines will need to be run to a spare PBX extension using a standard RJ12 phone
cable. Take note of the extension number(s) that the Telephone Router is being connected
to, as you will need to know which to dial when testing the unit.
© JTECH Communications, Inc.
Telephone Router
Page 11
Advertisement
Table of Contents
