Adjustment Of Chain; Greasing Procedures To The Driving Chain - Yukon Trail Puma 200 Owner's Manual

ADJUSTMENT OF CHAIN

1 When chain adjustment is needed, loosen rear axle bolt .
2 Turn the chain adjusting nuts on the left and right sides to
adjust the tension of the chain and to align the marking of
the chain adjuster with the engraved lines in the similar
position on both sides.
3 Tighten rear axle bolt by a torque of 50-60Nm (37-44 ft.lb.).
4 Repetitively check the tension of the chain.
1/2" - 3/4"

GREASING PROCEDURES TO THE DRIVING CHAIN

1 Shut off the engine
2 Add light amounts of machine oil or chain grease to the driving
chain. (Too much machine oil or chain grease may cause
splattering to occur.)
Attention:
The chain should be replaced when the adjusting limit has reached
it's maximum.
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
Rear axle bolt
Chain adjusting
nut Both Sides