Colubris Networks CN3000 Administrator's Manual page 351

Chapter 15 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Sample setup - Steel-Belted Radius - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Chapter 15
9. Go to Wireless > WLAN profiles.
10. Click the Colubris Networks profile.
11. In the Wireless protection box:
12. Click Save.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 351 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
When you click the Save button in the management tool, the number of Accepts
should be incriminated. That means that all settings are properly configured on the
CN3000 and Steel-Belted Radius.
If the number of Rejects is incriminated instead, there may be a problem with a
badly set username and/or password. Check the log file in c:\radius\service. It is
named yyyymmdd.log, where yyyy is the year, mm is the month and dd the day.
For example, 20030822.log for August 22, 2003.
If the number of Silent Discards is incriminated, it probably means that either the IP
address of the CN3000 and/or the shared secret has not been properly configured
on the RAS client tab.
You can increase the amount of information in the log file by changing the following
values in the c:\radius\service\radius.ini file, and restarting Steel-Belted Radius:
[Configuration]
LogLevel
TraceLevel
Change both values from 0 to 2.
• Enable 802.1x.
• Set RADIUS profile to RADIUS Profile 1.
= 0
= 0