Colubris Networks wap-200 Quick Start

WAP-200
This guide shows you how to start up WAP-200 intelligent wireless access point. For detailed configuration and operating information
see the WAP-200 Administrator 's Guide, which is available on the Colubris Networks documentation CD or at www.colubris.com
(select Support and then Product Registration).
IMPORTANT NOTE ABOUT WIRELESS SECURITY: To provide easy wireless access to the management interface, the WAP-200 ships with
all wireless security options disabled. Colubris strongly recommends that once the unit is installed you enable a wireless security option
to properly safeguard the wireless network from intruders. For more information see the administrator's guide.

Hardware overview

5 volts
Power Ethernet Wireless
light light light
Power connector

Package contents

• WAP-200 unit
• Two 2.4-GHz (2-dBi) / 5-GHz (2-dBi)
dual-mode omnidirectional antennas
• Mounting bracket
• Documentation CD
• Spring clip: If needed, insert into one of the screw holes in the
mounting bracket as shown to provide a tighter fit.
Antennas
The WAP-200 has a single radio with two antennas. It can create a single
wireless cell. The antenna connectors are reverse-polarity SMA jacks.
Antennas or cable connectors must use RP-SMA plugs.
Antennas can be attached directly or attached to the MAIN connector
using a coax cable.
42-10-0200-08
Quickstart
Front
Reset
Port 1
802.3af 10101
Serial port

Reset button

Antenna connector Antenna connector
MAIN AUX
Reset button
• To restart the WAP-200, press and quickly release the reset button.
• To reset to factory default settings, press and hold the reset button
until the status lights flash three times, then release.
Caution! Resetting the WAP-200 to factory defaults deletes all configuration
settings, resets the administrator username and password to
the IP address of port 1 through DHCP. If a DHCP server is not found connected
to port 1, the address 192.168.1.1 is assigned to port 1 and the wireless port.
Installation
Caution! Installation must be performed by a professional installer who is
familiar with local regulations governing wireless devices.
Caution! Shielded Ethernet cables must be used for all connections. Do not
connect the Ethernet ports directly to a metropolitan area network (MAN) or wide
area network (WAN).
When mounting the WAP-200 on a wall or ceiling, ensure that:
• The surface you attach the WAP-200 to and the fasteners you use can
support at least 5.1 kg (11.25 pounds).
• Cable pull, accidental or otherwise, does not make the unit exceed the
5.1 kg limit (11.25 pounds).
If the WAP-200 is installed inside a plenum, plenum-rated cables and
attachment hardware must be used. Only the WAP-200 and appropriate
cabling can be located in the plenum. PoE injectors available separately
from Colubris Networks cannot be installed inside a plenum.
Rear
admin,
and sets
1 of 2