Power Supplies - Nikon SMZ1000 Instruction Manual

Power supplies

4
Use the Power Supply XN A for regions using 100/120 V power, and the
Power Supply TN-PSE30W A for regions using 230 V power. Insert the
plug of the Halogen illuminator into the output connector located on the
rear of the power supply.
Input voltage display
Check that the voltage displayed matches the
voltage used in your area. If the voltages do
not match, do not use the power supply and
contact your Nikon representative.
Power Supply XN A (only for regions with 100/120 V power)
Brightness adjuster
Changes the illumination
brightness when rotated.
Power switch
Power Supply TN-PSE30W A (only for regions with 230 V power)
Power cord
Power switch
Brightness adjuster
Changes the illumination brightness when rotated.
Power cord
Illuminator
Fuse
Always use the fuse
specified.
(Rear view)
Output connector
Connect the
lamphouse cable here.
Input voltage display
Check that the voltage displayed
matches the voltage used in your area.
If the voltages do not match, do not
use the power supply and contact your
Nikon representative.
(Rear view)
Output
connector
Connect the
lamphouse cable here.
AC input connector
Connect the specified power
cord here.
V
27