Nikon SMZ1000 Instruction Manual page 15

[C-PS & C-PSC]
5
The stand arm can be lowered. (If you
do not need to lower the arm, jump to
step 6.)
Use the hexagonal wrench (large - supplied
with the focusing stand) to loosen the arm
fixing screw. Reattach the arm using the
screw hole at the lower side of the vertical
slider. The arm will become 55 mm lower
than its original position. Before tightening
the screw, make sure that the two pins on the
arm fit in the grooves on the vertical slider.
Mount the zooming body.
6
Lightly tighten the zooming body clamp
screw to hold the zooming body on the
focusing mount or arm.
Note) Do not over-tighten the zooming body
clamp screw since it may cause
damage to the instrument.
Screw the objective into the bottom of
7
the zooming body.
Mount the eyepiece tube.
8
Align the groove on the eyepiece tube with
the positioning pin on the zooming body, push
the eyepiece tube toward the back to attach.
Tighten it to the zooming body using the
supplied hexagonal wrench (small) or the
clamp tool supplied with the C-PS160.
II
Groove
Pin
Positioning pin
Groove
13