Removing Hot Swap Hard Drives - HP ProLiant ML150 Operation Manual

Installing and Configuring

Removing Hot Swap Hard Drives

1. Unlock the hot swap key lock above the hot swap mass storage cage before attempting to
remove the drive.
2. To unlock the drive, push the locking latch in and then pull the ejector handle toward
you.
3. Gently pull the drive straight out to disengage the connection from the back plane.
4. Wait about 30 seconds for the drive to stop spinning and the drive heads to park.
5. Use your hand to support the bottom of the drive, while you slowly pull the drive straight
out. Do not allow the drive to fall. Refer to Figure 2-10.
CAUTION: You must remove the drive slowly about an inch to disconnect from the back
plane and wait 30 seconds for the drive to stop spinning to ensure the drive heads are parked
prior to removal. Be sure you follow these instructions carefully to prevent handling damage,
such as head slaps or head actuator unlocking.