HP ProLiant ML150 Operation Manual page 31

5. Spread the two retaining latches outward to accept the DIMM.
6. Remove the HP DIMM from its protective container, handling the module by its edges.
If you must lay it down, place it on an anti-static mat.
7. Align the notch on the new DIMM with the key on the DIMM slot. Refer to Figure 2-12.
Figure 2-12: DIMM to slot alignment
Item
1
2
3
4
8. Hold the DIMM at 90 degrees to the system board and press the DIMM firmly and
evenly into the slot until the retaining latches close. Refer to Figure 2-13.
It is important to hold the DIMM firmly with both hands and use even pressure so it will
not bend or break the DIMM connector during installation. If the latches do not close, the
DIMM is not inserted correctly.
HP ProLiant ML150 Server Operations and Maintenance Guide
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:09 AM
Description
Notch
Key
Retaining Latches
DIMM slot
Installing and Configuring
2-17