AudioCodes Mediant 2000 Installation Manual page 26

Note:
Map outgoing calls to IP addresses (when Gatekeeper isn't used) by completing these steps:
5.
Click the arrow button next to the 'Tel to IP Routing Table' label; the 'Tel to IP Routing'
screen opens.
Any telephone number whose destination number matches the prefix defined in the
'Destination Phone Prefix' field and whose source number matches the prefix defined in
the adjacent 'Source Phone Prefix' field, is sent to the IP address entered in the 'IP
Address' field.
Click the Submit button; the 'Tel to IP Routing' table is automatically updated.
Click Quick Setup; you're returned to the 'Quick Setup' screen.
For more information on the 'Tel to IP Routing' table refer to the H.323 Mediant 2000 User's
Manual.
Enable E1/T1 B-channels by completing these steps:
6.
Click the arrow button next to the 'Trunk Group Table' label; the 'Trunk Group Table'
screen opens.
Select the number of the trunk you want to enable from the 'Trunk ID' drop-down list.
Enter the number of B-channels you want to enable in the 'Channels' field.
Enter the starting phone number in the adjacent 'Phone Number' field (these are virtual
numbers, used only to define enabled B-channels).
Click the Submit button; the 'Trunk Group Table' table is automatically updated.
Click Quick Setup; you're returned to the 'Quick Setup' screen.
Click the Reset button and click OK in the prompt; the Mediant 2000 applies the changes
7.
and restarts. This takes approximately 3 minutes to complete. When the Mediant 2000 has
finished restarting, the Ready and LAN LEDs on the front panel are lit green.
After the gateway is reset, configure the Mediant 2000 trunk parameters. For information on
8.
configuring the trunk parameters, refer to Section
Note:
Mediant 2000
The preferred coder is the coder that the Mediant 2000 uses as a first choice
for all connections. If the far end gateway does not use this coder, the
Mediant 2000 negotiates with the far end gateway to select a coder that both
sides can use.
H.323 users should continue with Section
on page 27.
3.5 on page 27.
3.5 Configuring the Trunk Settings
24
Mediant 2000
Document #: LTRT-70105