Advertisement
Step 3-Input Signal Switching
Select "Input" icon in title bar, user can click the signal
source that need, select, VSP 628 will automatically
update input signal source.
Step 4-Image Size and Position Setting
Select "Image" icon in title bar to scale the image, user
can modify digital setting parameters and image size
and position easily through "-+" icon. Click "Set" after
modify the digital, VSP 628 image will display the
latest Settings;
Step 5-PIP Setting
Select "PIP" icon in title bar. When the PIP sliding
block icon is grey, then it is single channel picture
mode, and if image selection is gray, then image 1 is
default for single image output image, and can't be
chosen.
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197
Email: rgblinkcs@gmail.com
Fax: 00865925771202
http://www.rgblink.cn
Then user can set PIP location, in addition to system
default PIP upper left picture, also can choose picture
above picture and picture edge picture.
In PIP mode, the default image1 is the main image,
image2 for PIP image2, click the corresponding image
when need to edit image1 or image2 , the selected
image with blue stripes, tick, as shown below: image2
is selected, all all settings will for image 2. For
example, you can switch "Input" icon in title bar to
choose image 2 input source.
NOTE
If image1 and image2 with the same input source, then
it will display the same picture in PIP.
Step 6-Save and Call
User can save the parameters to UserMode1 and
UserMode2, and can also load UserMode1 and
UserMode2 that saved before.
VSP 628 Quick Start
Rev 1.1
Page 6 of 7
Advertisement
