Orion AGB-21G Service Manual page 47

STEERING HEAD INSPECTION AND ADJUSTMENT
Tighten the steering ring nut
steering nut wrench
NOTE:
Apply the lithium soap base grease on the
thread of the steering stem.
Set the torque wrench to the steering nut
wrench so that they form a right angle.
Steering ring nut (initial tightening):
30 Nm ( 3 m • kg )
Loosen the steering ring nut one turn.
Retighten the steering ring nut using the
steering nut wrench.
WARNING
Avoid over-tightening.
Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
Install the upper bracket
ing stem nut
upper holder
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
Steering stem nut:
70 Nm ( 7 m • kg )
Handlebar upper holder:
25 Nm ( 2.5 m • kg )
3 - 25
.
, washer, steer-
, handlebar , handlebar
.
using