REAR SHOCK ABSORBER AND SWINGARM
4. Check:
spacer
Damage/wear
bearings
Damage/pitting
CHECKING THE DRIVE CHAIN
1. Measure:
10-link section a of the drive chain
Out of specification
chain.
NOTE:
While measuring the 10-link section, push
down on the drive chain to increase its tension.
Measure the length between drive chain roller
1 and
Perform this measurement at two or three dif-
ferent places.
2. Check:
drive chain
Stiffness
3. Clean:
drive chain
a. Wipe the drive chain with a clean cloth.
b. Put the drive chain in kerosine and remove
any remaining dirt.
c. Remove the drive chain from the kerosine
and completely dry it.
5-39
1
Replace.
2
Replace.
Replace the drive
10-link drive chain section
limit (maximum)
144.4 mm
as shown.
11
Clean and lubricate or replace.