8. Install:
Brake master cylinder
Brake master cylinder bracket
Bolt (brake master cylinder bracket)
NOTE:
Install the bracket so that the arrow mark
faces upward.
First tighten the bolt on the upper side of the
brake master cylinder bracket, and then
tighten the bolt on the lower side.
9. Install:
Engine start button
Engine stop switch
Bolt (clutch lever holder)
Clutch lever holder
Screw (Engine start button)
10. Install:
Bolt (clutch lever)
NOTE:
Apply the lithium soap base grease on the
clutch cable end .
11. Adjust:
Clutch lever free play
Refer to "CLUTCH ADJUSTMENT"
section in the CHAPTER 3.
Hot starter lever free play
5 - 34
HANDLEBER
9 Nm (0.9 m • kg)
9 Nm (0.9 m • kg)
4 Nm(0.4 m • kg)