IBC Qscan User Manual page 40

Proximity and iClass Input, Format # 3, Part 2*
X053 iss il b sc ic uc
iss issue code start bit
il # bits for issue code
b issue code is lsb
sc site characters
ic id characters
uc issue characters
This command is the second part of a 2 part command, for setting up an
input proximity or iClass format.
* added to firmware 5/22/13
Proximity and iClass Input, Format # 1 Mask, Part 1*
X054 p1 ll1 p2 ll2
p1 start position
ll1 length or constant
p2 start position
ll2 length or constant
p1 and p2 refer to the start position in the data to start an extraction of
data. The data is extracted for a length of ll1,ll2. If p1 or p2 is 00, then
ll1 or ll2 refers to a constant value which will be inserted into the data
value. The constant value is a 3-digit ascii decimal value of the character
to insert ("A" = 065). If both p1 and ll1 (or p2 and ll2) are 0, then that
portion of the mask is ignored. See the examples at the end of this
section.
Note this mask applies only to prox/iClass cards with a bit length defined
by prox/iClass format # 1.
* added to firmware 5/22/13
Qscan User's Guide
000=no issue
0=off
00=none
00=none
00=none
max=250
1=issue is lsb
max=20
max=20
max=20
00=ll1 is a constant
00=ll2 is a constant
Version 1.4
Page 0