IBC Qscan User Manual page 19

Symbology Setup 7
X007 a b c d e f g h
a Bookland
b Postbar
c Macro Pdf
d UCC coupon
e unused
f unused
g unused
h unused
Use this command to turn the listed symbologies and features on or off.
Length Settings for 2 of 5 Symbologies
X040 aa bb cc dd ee ff
aa I 2 of 5 length 1
bb I 2 of 5 length 2
cc M 2 of 5 length 1
dd M 2 of 5 length 2
ee D 2 of 5 length 1
ff D 2 of 5 length 2
Because of the structure of 2 of 5 barcodes, it is possible that reading
only part of the barcode will result in a valid decode, with undesired
results. To suppress this problem, it is best to use check digits with 2 of
5 symbologies (if available) or restrict the lengths for these barcodes so
that partial decodes cannot occur. You can program up to two different
lengths for each of the supported 2 of 5 symbologies. If you prefer to
leave it wide open, then you can set the lengths to 00.
0=off
0=off
(2d) 0=off
0=off
always 0
always 0
always 0
always 0
2 digit length
2 digit length
2 digit length
2 digit length
2 digit length
2 digit length
Qscan User's Guide
1=on
1=on
1=on
1=on
00=any length
00=any length
00=any length
00=any length
00=any length
00=any length
Version 1.4
Page 1