Lcd Gauge - Arctic Cat 2012 WildCat Operator's Manual

CAUTION
Never operate this vehicle with a EPS
code indicated on the LCD gauge/
speedometer. This indicates a mal-
function in the EPS system control
circuit and could result in a loss of
power steering assist.
In the event of electrical power failure,
the EPS system becomes disabled (simi-
lar to an automobile with the engine shut
off). Steering effort increases but steering
control can be maintained.

LCD Gauge

1. Clock/Hour Meter - The clock func-
tion indicates time in the 12 hour
mode; the hour meter indicates the
total time the vehicle has run and
cannot be reset to zero.
A. With the ignition switch ON, press
and release the Right Button (3) until
the clock is displayed in (1); then
press and hold the Right Button (3) in
until the clock display starts flashing
(approximately 2 seconds).
B. Press and release the Right Button (3)
to set minutes and press and release
the Left Button (4) to set hours.

NOTE: Approximately four seconds
after releasing either Button, the LCD
will return to normal operation.

NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Fuel Level Indicator - Indicates approxi-
mate amount of gasoline in the gas tank.

NOTE: When the bottom segment
flashes, approximately 3.8 L (1.0 U.S.
gal.) of gasoline remains in the tank.
28
3. Right Button - Shifts the bottom seg-
ments through five modes: odometer,
trip 1, trip 2, engine hours, and clock.
4. Left Button - Used to switch from
speedometer function to tachometer
function on the speedometer/tachom-
eter gauge.
5. Odometer/Trip Meter (#1 and #2) -
Odometer registers the total distance
the vehicle has traveled. Trip meters
can register two distances (for
instance, #1 could register trip dis-
tance and #2 could register distance
between stops). The trip meters can
be reset while the odometer only reg-
isters accumulated miles/kilometers.

NOTE: To select odometer (ODO),
trip #1 (T1), or trip #2 (T2), press
and release the Right Button (3)
until the desired display illuminates
in the LCD. To reset the trip dis-
plays, hold the Right Button (3)
down when the desired trip is dis-
played.
6. Gear Position Indicator - Indicates
which gear is selected.
7. Speed/Tach Indicator - Indicates
approximate vehicle speed in MPH or
KM/H when speedometer function is
selected or RPM when tachometer
WC034A
function is selected.
8. Speed Function Display - Displays
which speed function (MPH, RPM,
KM/H) is being indicated by the
Speed/Tach indicator.

NOTE: The speed and tach func-
tions may be switched from needle
to digital by pressing the Left But-
ton (4).
9. Differential Lock Indicator - Displays
LOCK when the differential lock has
been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the differential
lock is engaged.
11. High Beam Indicator - The High
Beam icon will appear only when the
lights are on high beam.