Checking/Adjusting Headlight Aim; Fuses - Arctic Cat 2012 WildCat Operator's Manual

3. Install the new headlight assembly
and connect the wiring harness.
4. Adjust the headlight using the Check-
ing/Adjusting Headlight Aim instruc-
tions in this section.
To replace the taillight/brakelight assem-
bly, use the following procedure.
1. Disconnect the taillight/brakelight
connector; then remove the lock nuts
securing the assembly to the mount-
ing bracket.
2. Remove the taillight/brakelight
assembly.
3. Install the new taillight/brakelight
assembly and secure with the nuts.
Tighten securely; then connect the
electrical connector.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The geometric center of the HIGH beam
light zone is to be used for vertical aim-
ing.
1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).
46
WC107A

NOTE: There should be an aver-
age operating load on the vehicle
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
5. Observe each headlight beam aim.
Proper aim is when the most intense
beam is 5 cm (2 in.) below the hori-
zontal mark on the aiming surface.
6. Adjust each headlight until correct
aim is obtained by turning the screw
with a 4 mm wrench counterclock-
wise to raise or clockwise to lower
the beam.
WC099A

Fuses

The fuses are located in a power distribu-
tion module under the passenger seat. If
there is any type of electrical system fail-
ure, always check the fuses first.

NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift out.
0740-647
WC098A