Troubleshooting - Vitrifrigo FG10I VFAU User Manual

9

Troubleshooting

The following table serves to provide some suggestions concerning the checks
to be made in case of incorrect refrigerator operation. If, after completing the
suggested checks, the refrigerator is still not operating regularly, contact your
EN
nearest assistance service.
Problem
The
refrigerator
will not start
The
refrigerator is
noisy
The cooling
power of the
refrigerator is
not sufficient
20
Probable Cause Solution
Power supply Make sure that the power cord is correctly plugged into
the power socket
Make sure the main power switch is on "I" position
Make sure that the automatic breaker on the system's
electrical panel is on
Make sure that the plug socket is working
Make sure that the power cord is not damaged and/or
broken
Thermostat Make sure that the thermostat is not set to OFF
Position Make sure that the refrigerator has been properly
levelled
Make sure that the refrigerator is not in contact
with furniture or other items that might increase its
vibrations
Refrigerant pipes Make sure that the pipes and/or components of the
refrigerant circuit are not touching. This is a check
that must only be carried out by a specialist service
engineer
Door closure Make sure that the door is correctly closed and also that
the gasket is not damaged in any point
Position Make sure that the refrigerator is not too close to a
source of heat
Condenser Make sure that the refrigerator is positioned so that the
condensation air can be discharged correctly (from the
rear panel)
Make sure that the condenser fan is rotating correctly
Check the condenser for dust and clean if necessary
Defrosting Make sure that the insides of the refrigerator are not
excessively covered in ice. Defrost if necessary