MTU 8 V 2000 M51A Operating Instructions Manual page 182

8. Install injection pump, observing marked in‐
stallation position.
9. Install securing screws of injection pump and tighten with torque wrench to the specified torque.
Name
Securing screw
10. Install fuel line (2).
11. Tighten union nut on the injection pump to the specified tightening torque using a torque wrench.
• Maximum permissible tightening torque: 35 Nm
Name
Union nut
12. Tighten union nut on the pressure pipe neck to the specified tightening torque using a torque wrench.
• Maximum permissible tightening torque: 35 Nm
Name
Union nut
13. Install injection pump wiring (1).
14. Use torque wrench to tighten screws to the specified tightening torque.
Name
Screw
Final steps
1. Remove barring device (→ Page 166).
2. Clean mating faces on cylinder head and charge-air manifold.
3. Check gaskets for damage and replace them, if required.
4. Coat gaskets with grease (Kluthe Hakuform 30-10/emulsifier) and place onto cylinder head.
5. Install charge-air pipes.
6. Install engine control system (→ Page 240).
7. Open fuel supply line before fuel filter.
8. Vent fuel system (→ Page 193).
182 | Task Description | MW15550/06E 2012-02
Size Type
Tightening torque
Size Type
Tightening torque
Size Type
Tightening torque
Size Type
Tightening torque
Lubricant Value/Standard
60 Nm + 12 Nm
Lubricant Value/Standard
20 Nm + 5 Nm
Lubricant Value/Standard
20 Nm + 5 Nm
Lubricant Value/Standard
1.0 Nm ± 0.2 Nm