MTU 8 V 2000 M51A Operating Instructions Manual page 153

Mtu 8 v 2000 m50a; 8 v 2000 m50b; 8 v 2000 m51a; 8 v 2000 m51b; 12 v 2000 m50a; 12 v 2000 m50b; 12 v 2000 m51a; 12 v 2000 m51b; 16 v 2000 m50a; 16 v 2000 m50b; 16 v 2000 m51a; 16 v 2000 m51b diesel engines
Hide thumbs Also See for 8 V 2000 M51A:
Table of Contents

Advertisement

Display text
Meaning
AL Output Stage
Fault message re. power amplifier, cyl‐
Bank 2 Fault
inder bank B
AL Override Activat‐
Safety system overridden
ed
AL Power Failure
Power failure of control system
Control
AL Power Failure
Power failure
Monitoring
AL Transistor Output
One of the ECU 4 transistor outputs
1/2 Fail
(TAA1 or TAA2) defective
AL Transistor Output
One of the ECU 4 transistor outputs
3/4 Fail
(TAA3 or TAA4) defective
AL Water in Fuel Pre‐
Water in fuel prefilter
filter
DL 211+A001-A001
DIS not recognized on default bus
DL 211+A001-A010
LCU of LOP 1 (PIM No. 21.X+A001-
A010) not recognized on default bus
DL 211+A001-A020
LMU of LOP 1 (PIM No. 21.X+A001-
A020) not recognized on default bus
Measure
1. Check LOP visually (→ Page 243).
2. Perform LOP test procedures
(→ Page 245).
3. Check ECU plug connection
(→ Page 238).
4. Check engine wiring (→ Page 234).
5. Contact Service.
• Have ECU checked and re‐
placed if required.
Status message:
• Override activated.
Check power circuit breakers and
fuses.
Check power circuit breakers and
fuses.
Contact Service.
• Have ECU checked and replaced if
required.
Contact Service.
• Have ECU checked and replaced if
required.
Drain fuel prefilter (→ Page 198).
1. Check LOP visually (→ Page 243).
2. Perform LOP test procedures
(→ Page 245).
3. Check ECU plug connection
(→ Page 238).
4. Check engine wiring (→ Page 234).
5. Contact Service.
• Have DIS checked and replaced
if required.
1. Check LOP visually (→ Page 243).
2. Perform LOP test procedures
(→ Page 245).
3. Check ECU plug connection
(→ Page 238).
4. Check engine wiring (→ Page 234).
5. Contact Service.
• Have MPU 23 of PIM No. 21.X
+A001-A010 checked and re‐
placed if required.
1. Check LOP visually (→ Page 243).
2. Perform LOP test procedures
(→ Page 245).
3. Check ECU plug connection
(→ Page 238).
4. Check engine wiring (→ Page 234).
5. Contact Service.
• Have MPU 23 of PIM No. 21.X
+A001-A020 checked and re‐
placed if required.
MW15550/06E 2012-02 | Troubleshooting | 153

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents