Motorola AP-8163 Installation Manual page 25

Installation Guide
6. Rotate the Access Point bracket section upward and align the top holes on the sides with the top holes
on the angle adapter bracket section. Insert two M6 hex flange screws into the top holes on the angle
adapter bracket section. Use a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench,
to finish attaching the Access Point bracket section to the angle adapter bracket section with the M6 hex
flange screws in the open slot connections and the top holes on the angle adapter bracket section. Do not
tighten the screws until all rotation and tilt adjustments are complete.
7. To adjust the position of the Access Point, rotate the Access Point bracket section (plus or minus 15
degrees) and tilt the angle adapter bracket section (up to 45 degrees).
8. Tighten all hex flange screws to 60 inch pounds (lbf-in).
To use the extension arm with the mounting hardware kit:
1. Attach the pole mount section at the desired mounting location using a U-bolt or band clamps.
2. Complete the steps for assembling and positioning the mounting bracket sections for poles less than or
greater than 3 inches. See
Vertical Pole Mount on page 21
.
25