Vertical Pole Mount - Motorola AP-8163 Installation Manual

Installation Guide

2.2.1 Vertical Pole Mount

Use the following procedure for vertical pole mount installations. The extension arm is recommended when
mounting the Access Point to poles greater than 3 inches is diameter.
For poles up to 3 inches in diameter when using a U-bolt:
1. Thread two 1/2 inch nuts onto the U-bolt.
2. Position the U-bolt on the pole and place the pole mount bracket section on the U bolt. Adjust the two 1/2
inch inner nuts until the pole mount bracket section is against the pole and the U-bolt can be secured
tightly to the pole at the desired mounting location.
3. Place the angle adapter bracket section on the U-bolt with the open slot connections on the bottom and
align it with the pole mount section. Attach with two 1/2 inch nuts. Tighten all nuts to 300 inch pounds
(lbf-in).
21