Spillage Monitoring System - Flavel Castelle Installation, Maintenance And User Instructions

Fig. 2
"LED" handset light
"STAR" / "OFF" button
5.2.7 To reduce the heat input, press the "DOWN / STANDBY" button until the
flame reduces to the low rate heat input setting. "DOWN" arrow on the
handset. To reduce the flame height of the main burner incrementally,
press the arrow momentarily. To reduce the heat input directly down to
the minimum level, press the "SMALL" flame arrow on the handset
twice. If you wish to turn off the fire altogether, press the "STAR" /
"OFF" button.
AFTER THE PILOT FLAME HAS BEEN EXTINGUISHED, IF YOU
WISH TO RE-LIGHT THE APPLIANCE YOU MUST WAIT AT LEAST
THREE MINUTES BEFORE TRYING TO RE-LIGHT THE FIRE.
5.3

SPILLAGE MONITORING SYSTEM

This appliance is fitted with a spillage monitoring system which shuts down the fire
if the evacuation of combustion products from the fire is affected by a partially or
fully blocked flue. If this system operates the fire will go out. If this occurs, leave
the fire for at least three minutes then follow the lighting procedure as
described in the previous section. In the event of repeated operation a GAS
SAFE registered gas installer must be called to investigate and rectify the
cause.
35
"UP" button
"DOWN" / "STANDBY"
button