Maintenance; Removal Of The Burner Assembly; Removal Of The Gas Valve - Flavel Castelle Installation, Maintenance And User Instructions

Servicing Notes
Servicing should be carried out annually by a competent person such as a GAS
SAFE registered engineer and must include an annual Oxy-pilot change. This is
a condition of the Flavel Fires guarantee schemes.
The service should include visually checking the chimney and fire opening for
accumulations of debris and a smoke test to check for a positive up-draught in the
chimney.
The condition of the logs should be checked and if necessary the whole set
should be replaced with a genuine replacement set.
The burner assembly is designed to be removed as a complete unit for ease of
access. After any servicing work a gas tightness check must always be
carried out.
Remote Control Fires - For Diagrams refer to section 2
4.1 Removing the Burner Assembly
4.1.1 Prepare work area (lay down dust sheets etc.)
4.1.2 Firstly remove the glass fascia assembly by removing the 2 off screws
at the L/H & R/H sides and then lift the glass fascia assembly clear, see
section 3.2 for diagram.
4.1.3 Remove the fuel-bed logs and bark chippings and L/H, R/H & central
ceramic inlays, see section 3.1 for diagrams.
4.1.4 Remove the 6 off screws to remove the burner gauze, then 4 off screws
to remove the ceramic support and finally 4 off burner mounting screws
then lift the burner unit clear of the firebox, see section 2.37 for
diagram.
NOTE : Please take care with the wiring.
4.1.5 To refit the burner assembly, re-assemble in reverse order and carry out
a gas tightness test. Refit the fuel-bed referring to section 3
for the correct coal layout. The fascia can now be replaced, see section
3.2 for diagram.
4.6 Removing the gas valve from the fire
4.2.1 Prepare work area (lay down dust sheets etc.)
4.2.2 Remove the burner assembly as described in section 4.1
SECTION 4

MAINTENANCE

29