Gabarron ADL 5030/14 Installation Instructions And User Manual page 9

4.- Remove the front outlet grill by removing the four screws. Remove also the
front panel by removing the two screws at the bottom of the heater.
5.- Attach the LH & RH spacers to the storage heater using the screws supplied,
in the same way as the screws are fixed in the upper rear section of the heater
side. Check the heater is separated 25mm from the wall at the top and bottom of
the heater (Fig. 2). Fit and screw the appliance to the anti-tilt device.
fig. 2
6.- Remove the inner front panel.
WARNING !
Warning. At the other side of this part there is a breakable panel of thermal isolation. It must be handle with care. Avoid
touching it.
7.- Place a row of storage bricks carefully, with the flat side heading the bottom of the heater. Insert one of the heating elements
in the holes in the right side insulation (Fig. 3).
fig. 3