Gabarron ADL 5030/14 Installation Instructions And User Manual page 7

1.- WARNING
Please read these instructions before installing or using this appliance for the first time. The warranty of the storage heater will
not cover any damage caused by non observance of any of these instructions.
This Guide must be kept and given to any new owner.
This appliance should not be used by disabled persons of any kind (children included) or without notice or knowledge of its
use, except in case they are instructed and supervised by a responsible person.
Should the heater be moved and reinstalled it is essential that the work is carried out by a fully qualified engineer.
If during any installation the thermal insulation shows any sign of damage, it is necessary for the faulty part to be removed and
replaced by an identical part.
The use of storage heaters is forbidden in any area where there is a presence of gases, explosives or inflammable objects.
Do not use this heater to dry clothes. Do not cover this heater or put objects in contact.
The air outlet grill at the top of the heater cabinet and the air inlet at the bottom of the heater are provided to ensure the most
efficient operation of the appliance. They also protect the heater from overheating; therefore, it is essential that at no time are
they covered.
Surfaces of this appliance could be hot. Children should be supervised to ensure they do not play with the heater.
Check the voltage in the rating label is the same than supply.
This heater should be switched off at the isolating switch before any repair work is carried out. This action should also be taken
during the times of the year when heat is not required.
The installation of the heaters must be carried out in such a way that each pole can be disconnected from the supply having a
contact separation of at least 3 mm.
The storage heater should not be installed just below an electrical socket.
The appliance must be installed in such a way that it is impossible for anyone using a bath or shower, to touch the controls.
The nominal charging time of this storage heater is indicated on its rating plate and must be controlled by means of a
programmer.
The installation must be carried out in accordance with the current electrical regulations.
This appliance must be earthed.
After installation a survey of the first charging cycle should be carried out to ensure that the main input thermostat switches off.
Ventilate the room during this first cycle.
Before carrying out any work inside the appliance, the heater must be disconnected from the electricity supply.
Never open a charged heater.
To maintain stability, it is essential that the heater is placed on a level surface and care should be taken to avoid irregular
surfaces, such as may result from carpets or tiled surrounds partially protruding under the heater.
The presence in the air of particles of smoke, dust and other pollutants could, in time, discolour the walls and surfaces around
the heater.
INTRODUCTION
Storage heaters are designed to take advantage of the considerable economical benefits of any restricted hour electricity tariff.
The heaters consume electricity only during the off-peak tariff, but due to the highly efficient storage medium, give you a truly
economical 24 hours of comfort temperatures. Supply with 220-240V~.
ADL
Model
2012/14
Input 1200W
220 –
Voltage
240V~
Máx. Charging
14 h
time
Charge 16 kWh
Weight 123 kg
Length 63 cm
Wide 24 cm
Height 66 cm
Bricks
INSTALLATION INSTRUCTIONS AND USER GUIDE
ADL
3018/14 4024/14
1800W
220 –
240V~
14 h
24 kWh 32 kWh
173 kg
81 cm
24 cm
66 cm
12 18
ADL ADL
5030/14
2400W 3000W
220 – 220 –
240V~ 240V~
14 h 14 h
40 kWh
225 kg 277 kg
99 cm 117 cm
24 cm 24 cm
66 cm 66 cm
24 30
ADL 2012 ADL 3018
2000W 3000W
220 – 220 –
240V~ 240V~
8 h 8 h
16 kWh 24 kWh
123 kg 173 kg
63 cm 81 cm
24 cm 24 cm
66 cm 66 cm
12 18
ADL 4024 ADL 5030
4000W 5000W
220 – 220 –
240V~ 240V~
8 h 8 h
32 kWh 40 kWh
225 kg 277 kg
99 cm 117 cm
24 cm 24 cm
66 cm 66 cm
24 30