Lcd Gauge - Arctic Cat 2015 Wildcat Operator's Manual

Code
C1310 Vehicle Speed High
C1311 Vehicle Speed Low
C1312 Vehicle Speed Faulty
C1313 Engine RPM High
C1314 Engine RPM Low
C1315 Engine RPM Faulty
C1316 EEPROM Error
C1317 CAN Bus Error
C1318 Internal CRC Error
C1319 Boot Counter Exceeded
C1320 Incorrect Vehicle Speed-to-RPM
Ratio
C1321 Vehicle Speed Erratic
C1322 Engine RPM Lost
C1323 "EPS OFF" Gauge Display
C1324 Loss of CAN communication with
EPS unit
C1325 Dual Loss
C1326 Rotor Position Encoder
C1327 Voltage Converter Error (Low)
C1328 Voltage Converter Error (High)
C1329 Internal Data Error

NOTE: Turn the key switch to the
OFF position then back to the ON
position to reset the malfunction
code. If the code continues to be
displayed, take your vehicle to an
authorized Arctic Cat Dealer for
EPS system
resuming operation.
CAUTION
Never operate this vehicle with an
EPS code indicated on the LCD
gauge/speedometer. This indicates a
malfunction in the EPS system con-
trol circuit and could result in a loss
of power steering assist.
In the event of electrical power failure,
the EPS system becomes disabled (simi-
lar to an automobile with the engine shut
off). Steering effort increases but steering
control can be maintained.

LCD Gauge

1. Clock/Hour Meter - The clock func-
tion indicates time in the 12 hour
mode; the hour meter indicates the
total time the vehicle has run and
cannot be reset to zero.
Fault Description
servicing before
A. With the ignition switch ON, press
and release the Right Button (3) until
the clock is displayed in (1); then
press and hold the Right Button (3) in
until the clock display starts flashing
(approximately 2 seconds).
B. Press and release the Right Button (3)
to set minutes and press and release
the Left Button (4) to set hours.

NOTE: Approximately four seconds
after releasing either Button, the LCD
will return to normal operation.

NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
2. Fuel Level Indicator - Indicates approxi-
mate amount of gasoline in the gas tank.

NOTE: When the bottom segment
flashes, approximately 3.8 L (1.0 U.S.
gal.) of gasoline remains in the tank.
3. Right Button - Shifts the bottom seg-
ments through five modes: odometer,
trip 1, trip 2, engine hours, and clock.
4. Left Button - Used to switch from
speedometer function to tachometer
function on the speedometer/tachom-
eter gauge.
5. Odometer/Trip Meter (#1 and #2) -
Odometer registers the total distance
the vehicle has traveled. Trip meters
can register two distances (for
instance, #1 could register trip dis-
tance and #2 could register distance
between stops). The trip meters can
be reset while the odometer only reg-
isters accumulated miles/kilometers.
WC034C
35