Hydraulic Brake; Brake Fluid; Brake Hoses - Arctic Cat 2015 Wildcat Operator's Manual

4. After all the oil has been drained,
install the drain plugs and tighten to
45 in.-lb.
CAUTION
Inspect the oil for any signs of metal fil-
ings or water. If found, take the vehicle
to an authorized Arctic Cat dealer for
servicing.
5. Pour recommended oil into each fill
hole.
6. Install the fill plugs and tighten to 16
ft-lb.

Hydraulic Brake

! WARNING
Be sure to inspect the brakes before
each use. Always maintain brakes
according to the Maintenance Schedule.

Brake Fluid

1. Check the brake fluid level in the
brake fluid reservoir. The fluid level
must be maintained between the
MAX and MIN level marks. If the
level in the reservoir is low, add DOT
4 brake fluid.
CF107A

NOTE: The brake fluid reservoir is
located on top of the master cylin-
der above and to the rear of the
CF106A
front left wheel.
2. Press the brake pedal several times to
check for firmness.
3. If the pedal is not firm, the system
must be bled.

NOTE: Take the vehicle to an autho-
rized Arctic Cat dealer for this service.
Be careful not to spill any fluid when
filling the brake fluid reservoir. Wipe
away spilled fluid immediately.

Brake Hoses

Carefully inspect the hydraulic brake hoses
for cracks or other damage. If found, take
the vehicle to an authorized Arctic Cat
dealer to have the brake hoses replaced.
Brake Pads
The clearance between the brake pads
and brake discs is adjusted automatically
as the brake pads wear. The only mainte-
nance that is required is replacement of
the brake pads when they show excessive
wear. Check the thickness of each of the
brake pads as follows:
1. Remove a front wheel.
2. Measure the thickness of each brake pad.
WC003
CAUTION
WC002A
45