Arctic Cat 2015 Wildcat Operator's Manual page 38


NOTE: To select odometer (ODO),
trip #1 (T1), or trip #2 (T2), press
and release the Right Button (3)
until the desired display illuminates
in the LCD. To reset the trip dis-
plays, hold the Right Button (3)
down when the desired trip is dis-
played.
6. Gear Position Indicator - Indicates
which gear is selected.
7. Speed/Tach Indicator - Indicates
approximate vehicle speed in MPH or
KM/H when speedometer function is
selected or RPM when tachometer
function is selected.
8. Speed Function Display - Displays
which speed function (MPH, RPM,
KM/H) is being indicated by the
Speed/Tach indicator.

NOTE: The speed and tachometer
functions may be switched from
needle to digital by pressing the
Left Button (4).
9. Differential Lock Indicator - Displays
LOCK when the differential lock has
been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the differential
lock is engaged.
11. High Beam Indicator - Appears when
the lights are on high beam.
12. EFI Malfunction Indicator - A mal-
function code and engine icon will be
displayed on the LCD whenever an
electronic fuel injection malfunction
code is detected. The LCD and speed-
ometer/tachometer will be normal, but
the malfunction code and engine icon
will continue to be displayed on the
LCD until the malfunction is corrected.

NOTE: Take the vehicle to an
authorized Arctic Cat dealer to have
the error corrected and the system
error reset as soon as possible.
13. Battery Condition Indicator - The bat-
tery icon will flash on the LCD when-
ever a low voltage (<9 DC volts) or
high voltage (>16 DC volts) is
detected at the ECM.
36
14. Temperature Indicator - The high
temperature icon will appear if the
engine overheats. After 30 seconds,
the temperature icon will continue to
illuminate and a code will be flashing.
The icon should not be visible during
normal operation.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.

NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.

NOTE: Debris in the engine com-
partment (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a gar-
den hose, wash the radiator and the
engine to remove any debris pre-
venting air flow.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.
15. Electronic Power Steering (EPS) Indi-
cator - Illuminates when there is a mal-
function in the power steering control
circuit A code will also be flashing.
16. Seat Belt Indicator - Illuminates for
approximately eight seconds after
ignition switch is turned ON.
17. Park Indicator - Illuminates when
Park is selected in the transmission.

NOTE: A (P) will also illuminate in
the gear position indicator (6).
Decreasing