Maintenance; Problem Solution; Environmental Protection - Worx D-LITE WX104 Original Instructions Manual

Variable speed control
The on/off switchis also a variable speed
switch that delivers higher speeds with
increased triggerpressure.
Battery capacity indicator
Battery capacity indicator shows battery
capacity when using.
LED light indicator
Before operation, the LED light will be activat-
ed when the On/Off switch is slightly pressed,
and will automatically turn off 20 seconds
after the On/Off switch is released.
• Overloaded: The tool is operated
in a manner that causes it to draw an
abnormally high current. In this situation,
release the Trigger Switch onthe tool and
stop the application that caused the tool to
become overloaded. Then pull the Trigger
Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the Tool
and Battery are overheated. In this situa-
tion, let the Tool and Battery cool before
pulling the Trigger Switch again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool will
not operate. In this situation, remove and
recharge the Battery.
Warning: To turn on the light, press
the On/Off switch and make sure the
Forward/Reverse Rotation Control is
on right/left position.

PROBLEM SOLUTION

1. WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the
trigger, is positioned in the lock function. Unlock the forward/
reverse rotation control by putting it into the required rotation
position. Push the trigger and the drill will start to rotate.
See Fig. D
2. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not used a
battery pack for a prolonged time will reduce the battery pack
working time. This can be corrected after several charge and
discharge operations by charging & working with your drill.
Heavy working conditions such as large screws into hard
wood will use up the battery pack energy faster than lighter
working conditions. Do not re-charge your battery pack below
0℃ and above 40℃ as this will affect performance.

MAINTENANCE

Remove the battery pack from the tool before carrying
out any adjustment, servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
See Fig. E
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery use and
storage is 0℃-45℃.
The recommended ambient temperature range for the
charging system during charging is 0℃-40℃.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for
recycling advice.
EN
15