Table of Contents
Advertisement
Adjustment procedure
Please follow the instructions below to perform the micro shift.
Step 1 :
LOOSEN the screws (1) fixing head 5-8.
These heads have to be shifted
screws number 3 (see drawings) both by 1/4 of a turn counter clock wise!
This is only a rough adjustment!!
Notes
•
This image is only intended for visual support, do not disassemble the heads. Only loosen the two
indicated screws.
Step 2 :
Tighten the screws (1) fixing head 5-8
Step 3 :
Print the file once again.
Step 4 :
Check if nozzle row 6A is shifted
row 6A has to be positioned exactly between 3A en 4B. Please refer to the picture below for
visual support.
8B
7B
Step 5 :
Adjust head 6 until it is well positioned.
Step 6 :
Adjust head 5, 7 and 8 until there are in one line with nozzle row 6B and between 6A.
Step 7 :
After this adjustment, head block 5-6-7-8 is shifted
1
/
inch. In general, the µ-shift can be accomplished by turning
720
1 = Screws (M2.5x5) fixing the head stationary plate
2 = Angle Adjustment screw
3 = Front and Back adjustment screw
1
/
inch compared with nozzle row 3A which means that nozzle
720
6B
5B
62
6A
6A
4B
3B
1
/
inch with head block 1-2-3-4
720
Installation Guide Blizzard
2B
1B
AP-75261 – Rev. 2.0 – 19/12/07
3A
3A
Advertisement
Table of Contents
