5.3.4 Connecting the network interface
5.3.4.1
Installation
The procedure for connecting the network interface is explained below.
To connect the printer to the network environment, follow the steps below.
Caution
•
F
OLLOW THE INSTRUCTIONS BELOW WHEN CONNECTING THE NETWORK INTERFACE CABLE
ELECTRICAL SHOCK OR FIRE MAY OCCUR
► D
O NOT TOUCH THE CONNECTOR
► D
O NOT CONNECT THE NETWORK CABLE CONNECTOR TO THE INTERFACE BOARD HAVING DIFFERENT
SPECIFICATIONS
Step 1 :
Power OFF the printer.
Step 2 :
Plug the connector of the Ethernet cable into the connector of the network interface board at the
back of the printer.
Step 3 :
Connect the other end of the Ethernet cable to the network.
Notes
•
R
"N
EFER TO
ETWORK INTERFACE BOARD OPERATION MANUAL
5.3.4.2
Specifications
Item
NetWork Type
Ethernet IEEE802.3
NetWork I/F
10 Base-T,100 Base-TX (automatic switching)
(RJ-45 connector, twisted pair cable, category 5)
Protocol
TCP/IP
Mode
Functions
.
.
.
•
ftp
•
socket
•
Automatic protocol recognition
•
Transmission speed up to 4 MB/s
"
TO USE THE NETWORK INTERFACE BOARD
Specifications
41
Installation Guide Blizzard
. O
,
THERWISE
.
AP-75261 – Rev. 2.0 – 19/12/07