Advertisement
Menu 3: Configuration of CPL
This menu allows associating the unit to the remote CPL programmer connected to the same
power grid.
"+"
In menu 3 press the
for 5 seconds. CPL message will start blinking.
Switch the CPL programmer, remote control desk to the "association" mode (see
corresponding manual). Press shortly the
"CPL"
screen and then
message confirming the association.
"
"
OK
Press
key to proceed with the following setting.
Menu 4: Backlight time settings
Adjustable backlight is available from 0 to 225 seconds in 15 seconds steps (90 seconds by
default).
"+"
"–"
To modify press
or
next setting.
Menu 5: Selection of temperature display in AUTO operation mode.
1 = Permanent display of the premises temperature.
0 = Permanent display of the set point temperature.
"+"
"–"
To modify press
or
configuration mode.
4. - CLEANING AND MAINTENANCE
The radiators do not precise any special maintenance providing thermal comfort during large periods. Clean dust with a dry, soft cloth only when
the unit is disconnected and cold.
Do not use solvents or abrasive products for cleaning.
After the heating season disconnect the radiator with the switch located on the back surface of the radiator.
This thermal radiator has been manufactured under an assured quality system using environment friendly processes.
Please take the heaters to a clean point once their useful life is finished, in order to recycle their materials in the right way.
5. - TROUBLESHOOTING
- The thermal radiator does not heat.
- The room does not reach the
required temperature.
- "-9.9ºC" ó "99.9ºC" message is
displayed
- "d2" or "d3" message is displayed
-"dEF" message is displayed
- Time settings are lost
- The keyboard does not respond
"+"
"EnrE"
key.
"
"
OK
, keys, then press the
to store and proceed with the
"
"
OK
, keys, then press the
to store and exit the
Check the heater or the air inlets are not covered.
Check the selected temperature is in accordance with the desired temperature. Maybe the room needs
more heating power.
Sensor wrong connection. Contact the after sale service.
Sensor wrong connection. Contact the after sale service .
CPL connection trouble. Contact the after sale service.
There was electric supply shortage or the unit had been disconnected by the main switch
bloc
If the
for several seconds to unlock the keyboard.
message displays on the
message is displayed, the thermal radiator keyboard is locked. Hold two central keys
10
1
2
3
4
5
6
7
OK
>5 sec.
1
2
3
4
5
6
7
OK
1
2
3
4
5
6
7
OK
Advertisement
