Weekly Programmes; Cleaning And Maintenance - Gabarron RF Series Installation Instructions And User Manual

WEEKLY PROGRAMMES

It is possible to allocate different programs to different days of the week. To do this, the controller has to be
upgrade from 24h mode (factory default) to 24h/7days mode as follows:
Move the selector to 0 position, the display will be Off. Press the key and at the same time turn the
selector to P position maintaining the key at least five seconds. The display will show P-SE which means
that weekly mode has been set.
SETTING THE DAY: Press the key more than two seconds and the display will show the number of the
day. Set the correct number, if required, by pressing + or – keys. Press the key and the display will show
now the time. Press again the key and new values will be stored.
To check a programme or to make a new one press PRG key: The display will show dia1 . Press again
PRG key and the display will show 00:00 intermittently. Follow now the steps from DAILY PROGRAMMES
section until the display shows again dia1 . Repeat this process with the 7 days of the week. When the
display shows dia7 the weekly program will be stored by pressing + key.
If the display shows dia1 then, pressing + key more than three seconds will copy the day 1
program to day 2 and so on.
It is possible to allocate any of the three temperature levels to all the intervals of any day
maintaining the relevant  key until an audible signal is heard.
To turn back a controller from 24hr/7days to a single 24h press PRG key more than six seconds. This will
restore the factory default settings.
KEYBOARD LOCK
Press the  key more than six seconds and the keyboard will be locked. The display will show and
the controller will keep on working internally. To unlock the keyboard press again the  key more than six
seconds.

4. CLEANING AND MAINTENANCE

Clean and dust with a dry, soft cloth only when the unit is disconnected and cold.
Do not use solvents or abrasive products for cleaning.
This thermal radiator has been manufactured under an assured quality system using environment friendly
processes.
Please take the heaters to a clean point once their useful life is finished, in order to recycle their materials in
the right way.
21