Table of Contents
Advertisement
Setup
3. Setup
AC Power
Power Linking
AC Plug
Fuse Replacement
DMX Linking
DMX Connection
COLORado™ 2 Tour User Manual Rev. 01e
The COLORado™ 2 has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product's user manual or on the product's sticker.
Always connect the COLORado™ 2 Tour to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the COLORado™ 2 Tour see the label affixed
to the side of the fixture. Alternatively, you may refer to the corresponding
specifications chart in the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
Please refer to the Sizing the Circuit Breakers section in the Appendix chapter of this
manual.
Never connect the COLORado™ 2 Tour to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to
100% switch.
The COLORado™ 2 Tour supports power linking for up to five other COLORado™ 2
Tour fixtures at 120 VAC. Each COLORado™ 2 Tour has Neutrik POWERCON
sockets for Power In and Power Out. Although the fixture comes with a power input
cord, it comes with no power linking cord.
The COLORado™ 2 Tour comes with a power input cord terminated with a NEUTRIK®
powerCON A connector on one end an Edison plug on the other end (US market). If
the power cord that came with your fixture has no plug or you need to change the
Edison plug, use the table below to wire the new plug.
Connection
Wire (US)
AC Live
AC Neutral
AC Ground
Green/Yellow
The COLORado™ 2 Tour fixture has no external fuse for the user to change. However,
it does have an internal fuse that only an authorized CHAUVET® technician should
change.
If you are using the COLORado™ 2 Tour with a DMX controller, you can link them
using a regular DMX serial connection. If using other DMX compatible fixtures with the
COLORado™ 2 Tour, it is possible to control them individually with a single DMX
controller.
It is also possible to run several DMX compatible fixtures synchronized without a DMX
controller in a master/slave operating mode.
If you are not familiar with the DMX standard, please refer to the DMX Primer and DMX
Connectivity sections in the Appendix chapter of this manual.
The DMX Channel Summary section in this chapter contains a brief description
of what COLORado™ 2 Tour features have a DMX channel assigned to them. The
Operation chapter of this manual provides a detailed list of the COLORado™ 2
Tour DMX channel assignments.
The COLORado™ 2 Tour uses the DMX data connection for its DMX modes, TOUR,
ARC1, AR1 + D, ARC2, AR2 + D, AR2 + S and HSV. Refer to the Introduction chapter
for a brief description of this modes and the Operation Instructions chapter to learn how
to configure the COLORado™ 2 Tour to work in these modes.
-6-
Wire (Europe)
Black
Brown
White
Blue
Green/Yellow
Screw Color
Yellow or Brass
Silver
Green
December 11, 2009
Advertisement
Table of Contents
