Operating Modes; Acquisition Control; Acquisition Mode; Single Frame - JAI GO-5000M-PGE User Manual

8.

Operating modes

8.1.

Acquisition control

Acquisition control contains the following commands.
Table-16 Acquisition control command
Command

Acquisition Mode

Acquisition Start
Acquisition Stop
Acquisition Frame Count
Acquisition Frame Rate
Acquisition Frame Rate
Raw
8.1.1 Acquisition Mode
In the GO-5000-PGE, the following three acquisition modes are available.
8.1.1.1

Single Frame

In single frame mode, executing the AcquisitionStart command causes one frame to be captured.
After one frame is captured, this operation is automatically stopped.
In order to restart the capture, it is necessary to input the AcquisitionStart command again. BlockID
is not reset until AcquisitionStop is input and is incremented when the AcquisitionStart command is
called.
◆ Normal single frame operation
1) AcquisitionStart command is input
2) AcquisitionActive becomes "TRUE" (accepts capture)
3) 1 frame is output
4) AcquisitionActive becomes "FALSE" (stop capturing)
5) Output is stopped
GO-5000M-PGE / GO-5000C-PGE
Parameter
Single Frame
Multi Frame
Continuous
No(EXE command)
No(EXE command)
1～255
0.125 to Maximum
FrameRate
8sec to Minimum
FramePeriod
- 34 -
Desctiption
One frame can
AcqusitionStart command
The number of frames which is specified
in Acquistion Frame Count, are output by
AcquisitionStart command
Images are continuously output by
AcquisitionStart command until
AcqusitionStop command is input.
Start Acquisition
Stop Acquisition
Set the number of frames to be used in
Multi Frame mode.
Set the frame rate in fps value
Set the frame rate in Frame period (μs)
be output by