Table of Contents
Advertisement
5.4
JAI SDK and Control Tool software
The GO-5000M-PGE and GO-5000C-PGE are designed to use the JAI SDK and Control Tool software to
control camera functions. All controllable functions are stored in the camera's XML file. The JAI SDK
can be downloaded from www.jai.com. Third-party software can also be used with the camera
provided it is compliant with the GenICam
5.5
Cables to be used
GigEVision configures the system by using 1000BASE-T.
In the market, CAT5e (125MHz), CAT6 (250MHz) and CAT7 (600MHz) cables are available for
1000BASE-T. There are crossover cables and straight through cables available. Currently, as most
equipment complies with Auto MDI/MDI-X, please use straight through cables. (Among crossover
cables, a half crossover type exists, which the Ethernet will recognize as 100BASE-T).
The GO-5000-PGE also has PoE (Power Over Ethernet) capability and DC power is supplied through
LAN cable.
5.6
DC IN / Trigger IN
The GO-5000-PGE supports a PoE (Power over Ethernet) function which complies with IEEE 802.3af.
Therefore, the Gigabit Ethernet interface card used in the PC needs to have this capability too.
However, if the Gigabit Ethernet network card does not have this capability, GO-5000-PGE provides
a 6P connector to receive +12 to +24V DC to operate the camera. The 6P connector is also used to
provide external trigger input.
5.7
Camera Default Settings
When the camera is connected to a PC and JAI SDK 2.0 is started up, an XML file which stores default
settings of the camera is downloaded to the JAI_SDK camera control tool.
The default settings of the GO-5000-PGE are as follows.
Table – 2 Default settings
Image Format
Trigger Operation
Exposure Control
Gain
Note: GO-5000M-PGE only.
GO-5000M-PGE / GO-5000C-PGE
®
standard.
Bit allocation
Height
Binning Horizontal (Note) OFF
Binning Vertical (Note)
Trigger Mode
Exposure Mode
Gain Auto
Manual
Gain all
Manual
Fine Gain all
Analogue Base Gain
- 14 -
8-bit
2048
OFF
OFF
OFF
OFF
0
0
0dB
Advertisement
Table of Contents
