Quick Reference; Attaching The Stand - Sharp AQUOS LC-80LE642U Operation Manual

QUICK REFERENCE
Before attaching the stand to the TV. build a work 2
table on which to rest the R/.
® To build the table, use the cushioning materials
used in the packaging.
® Of the cushioning materials used, TOP-C is also
used during sland unit assembly. Be sure to
assemble the stand unit before building the work
table.
TOP-L TOP-R
\_ -TOP-C 3
The case is equipped with push-in tabs to
hold the cushioning materials in place. Push
in the tabs (2 for each location) to secure the
cushioning materials in the case.
Push-in tabs
After you have built the work table, spread a
blanket or similar soft cloth over the table and
then lay the TV display down on the covered
table before attaching the stand to the IV.
Do not use a small table for this.
Refer to the operation manual for information on
attaching the stand.
Insert each of the cushioning materials in the
respective directions shown in the figure.
Insert TOP-L and TOP-R into the left and right
sides of the case respectively.
Insert TOP-C to fR between the lines on the other
side of the case.
TOP-L
CASE
LINE
® Before attaching (or detaching) the stand, unplug the AC cord.
® Before performing work spread cushioning over the base area to lay the IV ors. This will prevent it from
being damaged.
Be sure to follow the instructions, incorrect installation of the stand may result in the rv falling over,
1
2
Confirm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
_ Set the post for the stand unit onto the
polystyrene foam.
_2_Attach the base to the post.
_ Insert and tighten the 8 screws into the 8
holes ors the bottom of the base.
Hold the stand unit securely with one hand,
and then tighten the screws.
3
4
Build the work tame.
Insert the stand into the openings on the rear of
the rv.
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tiring of the
TV set.
5 Insert and tighten the 4 screws into the 4 holes
on the rear of the stand unit.
Short screws
TOP-C
I o In the installation procedure, be careful not to catch your fingers between the V ..... _ |
TV set and the floor. /i '/ /
o Do not remove the stand from the 13! unless using an optional wall I; ,'I |
mount bracket to mount it. [' X,,_,!_J' / |
o After attaching the stand to the TV, do not hold the stand when you _--_--_'___ |
put up, set up, move or lay down the TV. //_ J
_-6