Sharp AQUOS LC-80LE642U Operation Manual page 15

Connecting to External Equipment
[] When connecting an AV amplifier for a surround system
HD Cable/Satellite set-top box
HDMI-certified cable "1
Refer to page 40 for a list of PC signals compatible with the fV,
[] When using an HDMI cable (HDMI 1, 2, 3 or 4):
HDMl=certifled cable
Optical fiber cable *2
Letting the TV output the audio to an AV amplifier:
"1 When you connect ARC-compatible equipment, use the HDMI 1 terminal.
*2 If the equipment to be connected is not compatible with the ARC, connect an optical fiber cable.
Depending on the board, only video signals may be output. In this case, in addition to connecting an HDMI-certified
cable to the HDMI 2 terminal, connect a Q 3.5 mm stereo minijack cable to the AUDIO iN terminal and set "Audio
Select" to "HDMl+Analog". (See page 39.)
The HDMI terminals only support digital signal.
[] When using a DVI-HDMI conversion cable {HDMI 2):
If the image is not in sync with the audio, check the settings of the connected surround system.
[] When connecting an audio amplifier
It is possiMe to output audio through the DIGITAL AUDIO OUT terminal. (See page 24 for details.)
Optical fiber cable
When using a DVI-HDMI conversion cable, you should make an analog audio connection, in this case, in addkion to
connecting a DVI-HDMI conversion cable to the HDMI 2 terminal, connect a © 3.5 mm stereo minijack cable to the
AUDIO iN terminal and set "Audio Select" to "HDMl+Analog". (See page 39.)
[] When using an analog RGB cable {PC IN):
©3.5 mm stereo minUack to RCA audio cable
A
Analog RGB cable
(D-sub 15-pin cable or VGA cable)
© 3.5 mm stereo minijack cable
See page 2o for details on the Output Select function.
When using an analog RGB cable, input the audio signal to the AUDIO IN terminal of PC iN.
When connecting a PC to the PC IN, set "Audio Select" to "Video+Audio". (See page 39.)
@9" 13