Powertronix PTX 2 M Series User Manual page 29

User manual 6/10 kVA Rev.2
5. Troubleshooting
LED Status /
Audible Alarms
Battery discharging
time diminishes
The UPS cannot
power on after
pressing the ON
button
POWERTRONIX .
Possible Cause
Battery not yet
been fully charged.
UPS overloaded.
Battery aged.
The "ON" button is
pressed too briefly.
The UPS is not
connected to the
battery or the
battery pack
voltage is too low.
UPS fault.
- Page 25 of Total 29 -
Action
Keep UPS connected to utility power
continously for more than 10 hours to
recharge the batteries again.
Check the loads and remove the non-critical
equipment.
Replace the batteries. Please contact the
distributor to obtain the parts and
replacement service.
Press the "ON" button for more than 1 second.
Check the battery or recharge the battery.
Please contact the Sales Representatives.
January 2006