Elation Vision Scan 250 Manual page 36

1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed, press ENTER.
3. Tap the UP button until "SC01" is displayed.
4. The display indicates "SC01," this stands for the first scene of your program.
You may recall up to 48 scenes. For example, if you choose "SC05," and then
select the "Run" function, the first 5 scenes you saved in "Edit" mode will run.
5. Press ENTER to save and MODE/ESC to exit.
Editing procedure 1: Using the control board only.
1. Access the main menu.
2. Tap the UP button until "EDIT" is displayed and press ENTER.
3. The display will show "SC-01" , this stands for the scene number. For
example, "SC-01" is displayed, it means you will be editing scene 1, press
ENTER. You can change the scene number by tapping the UP button.
4. Press ENTER, the display will show "C-01," this represents the channel number.
If "C-01" is displayed, you will be editing the fixture's channel 1 value of the
selected scene, press ENTER. You can change the channel number by tapping
the UP button.
5. The display will show the DMX value for the channel that is being edited. It will
be displayed as "11XX," it stands for Channel 11 of the editing scene, the DMX
value is "XX."
6. Adjust the DMX value by tapping the UP button, until you get the expected effect
for this channel.
7. Press ENTER to enter the editing of the other channels of the scene.
8. Repeat steps 5-8, until you finish setting all the DMX values for all the channels
of this scene, each scene can have 15 channels maximum.
9. Once all the channels are completed, the display will begin to flash "TIME," this
indicates the time needed to run this scene.
10. Press ENTER to edit the time needed, the display shows "T-XX", "XX"
stands for the time needed to run this scene. For example, "T-02" means
scene 1 needs 6 seconds to run, "T-15" means this scene needs 45 seconds
©Elation Professional® 36
Vision Scan 250™
Vision Scan 250™