HAKO Citymaster 2000 1480 Operating Manual page 71

Accelerator pedal
Fig. 26:
X56b320.fm
Different drive modes are available which can be selected according to
the task at hand. Normally, the vehicle is operated in automotive mode. In
this case, the accelerator pedal 55 regulates the speed of the diesel
engine:
Accelerator
•
Tread down
•
55 Release pedal slowly
•
Release pedal fully
Note!
The maximum speed possible is dependent on the drive mode
selected with the tip switch 115.
The strong braking effect of the hydrostatic drive which occurs
when the accelerator is suddenly released represents a risk of the
wheels on the rear axle blocking in the event of bad weather condi-
tion (wet or dirty roads, ice and/or snow)!
When the vehicle brakes are applied abruptly with the hydrostatic
drive or the foot is removed from the accelerator pedal suddenly,
the brake lights are switched on to warn following traffic.
Attention!
In the case of hydraulic oil temperatures under 10 °C, the diesel
engine speed is reduced by the drive control to prevent damage
to the hydraulic pumps.
Attention!
The drive control is limited by a sensor on the pressure filter in
the case of a soiled pressure filter. Under certain conditions, the
vehicle no longer reaches top speed.
The "PRESSURE FILTER SOILED!" warning message appears.
Replace the pressure filter cartridges!
Effect
•
Engine speed, driving speed increase
•
Engine speed, driving speed decrease
•
Braking effect of the hydrostatic drive and
diesel engine takes effect
Operation
3-39