Attachment Devices - HAKO Citymaster 2000 1480 Operating Manual

3.5.13 Attachment devices

Fig. 91:
X56b350.fm
If nothing else is stipulated by the manufacturer, attachment devices may
only be operated in work mode! Only the attachment devices approved by
Hako GmbH may be installed and operated. The following informa-
tion only relates to attachment devices such as: snow plows, dozer blades
or front sweeping unit.
Danger!
Attachment devices which are not properly fixed to the quick
coupler could fall off while driving, representing a
Always fix attachment devices with fixation facilities intended
for attachment devices!
Observe the information in the attachment device manufac-
turer's operating manual!
Only those attachment devices may be installed and operated
which have been approved by Hako GmbH or are
offered as retrofit equipment by them and comply with the
applicable installation directives!
In the case of particularly heavy attachment devices, it may be necessary
to add ballast to the vehicle; observe permissible axle loads and minimum
axle loads.
Danger!
If the load applied to the rear axle after installation of an
attachment device is below the minimum value, it can cause
critical driving situations particularly in the event of abrupt
braking. There is a
Maintain the minimum axle load on the rear axle!
Do not exceed axle loads and admissible total weight!
Pay attention to the following procedure when lowering the front attach-
ment holder:
•
Remove the coded plug 136.
•
Disassemble the hydraulic hoses.
•
Open the chokes A of the two hydraulic cylinders on the front
attachment holder.
136
A
Risk of accident!
Risk of accident!
Operation
3-91