Table of Contents
Advertisement
OPERATING THE FIRE
a)
Light the pilot by depressing the control knob at the "off" position and
turn anti-clockwise (with the control depressed) to the second position
marked *.
b)
When the pilot lights, (pilot can be seen through the bottom window of
right hand radiant) hold the control knob down for 10 seconds.
c)
If the pilot fails to light, repeat the ignition sequence and hold in the
control knob for slightly longer.
d)
When the pilot has lit, release the control knob from the depress
position, depress slightly again and turn the control anti-clockwise to the
HIGH position and check for clearance of combustion products as
detailed below.
WARNING
If the fire goes out for any reason or is turned off and it is
necessary to relight the fire it is important to allow the fire to cool
for 3 minutes before attempting to re-light it.
CLEANING THE DRESSGUARD OR REFLECTOR.
Remove the dress-guard by pulling the location wire out at the top, and lifting
away. See fig. 2
Clean the dress-guard or reflector by wiping with a damp cloth, and polish with a
dry duster. DO NOT USE ABRASIVE CLEANERS
CLEANING THE CASE.
Dusting is normally all that is required. But where extra cleaning is necessary, use
a damp cloth.
Fig. 2
4
Hide quick links:
Advertisement
Table of Contents
