Replacing Battery - Toyota KUN26L-P series Owner's Manual

To set the function (b)
D
1. Push the lock switch on the wireless
remote control key twice. Within the
next 2 seconds, push the unlock switch
once. The turn signal lights will flash
twice.
2. Within 10 seconds, set the desired
condition by pushing the lock and un-
lock switches according to the following
table.
Automatic Operation
locking/ locking/
unlocking
Step 1 Step 2
function
Push lock
Push
switch
On
unlock
once
switch switch
once
Push lock
within 2
switch
Off
seconds
twice
Push lock
Cancel
switch
the set- three or N/A
tings more
times
16

—Replacing battery

For replacement, use a CR2016 lithium
battery or equivalent and a flat−bladed
screwdriver.
Special care should be taken to pre-
vent small children from swallowing
the removed battery or components.
z When replacing the battery, be care-
Settings
ful not to lose the components.
response
z Replace only with the same or
equivalent type recommended by a
Turn sig-
nal lights
Toyota dealer.
flash
z Dispose of used batteries according
once
to the local laws.
Turn sig-
nal lights
Replace the battery by following these
flash
procedures:
twice
CAUTION
NOTICE
12h015a
1. Open the cover using a flat−bladed
screwdriver wrapped with plastic tape.