Release Handle Clamp - Maximum Controls Max Phantom 2000 Installation And Owner's Manual

release handle clamp

Adjustment:
Tighten the Adjustment bolt until desired result is achieved.
The release handle clamp has been factory adjusted and
SHOULD NOT need any adjustment.
IMPORTANT: The red handle MUST BE FIRMLY secure in the
HORIZONTAL position.
IMPORTANT: The arm MUST NOT slip
when the gate is cycling or the gate OPEN
and CLOSE limit positions will NOT be
LEARNED. Gate speed will remain slow if
gate positions are NOT learned.
Re-Attach to Operator:
Limit pin MUST fit into slot in bottom of
release handle clamp directly under the
arm when reattaching arm to operator.
Arm
Adjustments
Slot
Limit Pin
Limit Tabs
factory set bolt
DO NOT adjust
Release Handle Clamp MUST be
NO
HORIZONTAL when FIRMLY secured.
After Release Handle Clamp is in the SECURE HORIZONTAL
position:
Pull the arm. NO slippage should occur.
If it does, readjust.
NOTE: When limit tabs are already set and the release handle is put
back in the secure position but the gate is NOT in the full open or close
position, the operator will automatically re-align the gate's open and
close tabs. No readjustment is necessary.
Adjustment
Bolt
35