Washers - Hobbico BrightStar 40 AWARF Manual

pointed straight up just under the top of the tank. The
rubber stopper must seat over the lip of the tank. Make
sure that the tubes are positioned side-to-side. Tighten
the stopper by turning the screw. Do not overtighten or
you may strip the threads in the plastic disk.
Install the foam tank collar and bend
the tubes
D 37. Locate the foam tank collar. Remove the
inner foam circle and place the collar around the
neck of the fuel tank. Bend the aluminum tubes
outward slightly, as shown.
Install the tank
D 38. Insert the fuel tank into the fuselage. Make sure
the foam collar is seated well against the firewall.
Attach fuel tubing to the tank
D 39. Cut two 6" pieces of medium silicone fuel tubing
(not included). Slide one piece onto each of the
aluminum tubes coming from the fuel tank.
Install the throttle pushrod
D 40. Attach the "Z" bend of the remaining 1/16" wire
pushrod into the inside hole of the carburetor
control arm.
Mount the engine
D 41. Insert the throttle pushrod into the pushrod
guide tube and position the engine on the mount so
that the face of the engine thrust washer is 1/4"
forward of the fuselage sides. Align the engine so the
crankshaft is pointing straight forward.
Using the engine mounting plates, 6/32" lock washers,
6/32" nuts and 6/32" x 3/4" screws, secure the engine
into position.
17