Speedometer/Lcd (Digital) (Xtx) - Arctic Cat PROWLER XT Operator's Manual

 NOTE: Clock memory power is
supplied through
accessory fuse and verified during
gauge "power-up" and reset. In the
event of clock memory power fail-
ure (blown fuse, etc.), the gauge
will "power-up," reset, and shut
down repeatedly until clock mem-
ory power is restored. Always
check the 15-amp accessory fuse
if this gauge condition is noted.
6. Gear Position Indicator - Indicates
which gear is selected - R (reverse)/
N (neutral)/L (low range)/H (high
range).
7. Engine Hour Meter Indicator - Indi-
cates engine hour meter mode is
selected on the display.
8. Speedometer Indicator Display -
Displays which function (MPH, km/
h, or RPM) is being displayed.
To change mph/km/h display, press
and release Set Button (4) until the
icon (MPH/KPH) appears; then press
and hold the Set Button (4) to change
the display.
9. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator - Displays 4WD
when selected by the drive select switch
or when the 4WD lock is engaged. The
display is blank when in 2WD.
11. High Beam Indicator - The High
Beam icon will appear only when
the headlights are on high beam.
12. Odometer/Trip Meter Indicator Dis-
play - Displays which function (ODO,
Trip, or Trip 2) is selected.
13. Speedometer - Indicates the approxi-
mate vehicle speed (MPH or km/h).
32
the 15-amp
Speedometer/LCD
(Digital) (XTX)
1. Speedometer/Tachometer/Condition
Warning Display - Indicates the
approximate vehicle speed (MPH or
km/h) or RPM. Warns of a system
error condition requiring attention.
The LCD will go blank except the
word VOLT will flash on the LCD
whenever a low voltage (<9 DC volts)
or a high voltage (>16 DC volts) is
detected. When voltage returns to nor-
mal, the gauge must be reset by turning
the ignition key to the OFF position
and then to the ON position.
The letters EFI (digital/analog gauge)
or a diagnostic trouble code (DTC)
(digital gauge) will flash on the LCD
whenever an EFI system error is
detected. After 30 seconds, the gauge
will return to normal, but the letters or
code will continue to flash until the
malfunction is corrected.

NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the error corrected and the system
error reset as soon as possible.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.

NOTE: When the bottom segment
flashes, approximately 3.5 L (0.92 U.S.
gal.) of gasoline remains in the tank.
3. Mode Button - Press and release to
shift the gauge between MPH or km/h
and RPM. Press and hold to switch
between MPH and km/h.
EFI011B